Any posts without this information may be removed and only restored when the information is supplemented. Create a Wizard Holes You must include as much useful information as possible when asking for help or advice. Create 2D High Speed Dynamic toolpaths. Create a classic 2D toolpath. Define a tool plane and stock.
![]() ![]() Mastercam X4 Hole Plane Series Of HolesCan I still use one so I can use the same sub program for the locations? Or can I use a Z move above the Z plane after the G13 line and then have it go to the subprogram to redo the G13? I have attached the program in a comment below. However I noticed that in the Haas milling book it doesn't have an R value listed as an option. The center drill and regular drill are using a G81 & G83 with a subprogram for the hole locations, and they have an R value to come up to 0.1" above Z to move to the next hole. I have a series of holes to mill out that are a non standard size, so I have them center drilled, drilled with a drill close to the size of the hole, then I'm planning on using a G13 to finish them. Meme posts that are not funny may result in a permanent ban and possible curse to post author.Piracy of any kind is not permitted and may cause a permanent ban Other subreddits you may be interested in:So I'm writing a program for school and had a question about G13 codes. Memes are not permitted, unless they are CNC related AND funny. Canoscan lide 60 64 bit driversI'm paranoid about it, and program length isnt an issue at school. I haven't finalized my feeds and speeds yet either, just filled them in with a general value until I know the program will work then I'll run the calcs.Edit: It looks like the G12&G13 are non-modal, so does that mean I need to do each hole individually rather than use the sub program? If so, easy enough with copy and paste, but just want to make sure.G13 D03 F12 K0.590 I0.42 Z.125 L5 (POCKET)(other program stuff) G17 G49 G40 G80 G90Does that seem like it would work? I know I have double G00 Z1.0 moves in there, but it was more of a safety thing.
0 Comments
Leave a Reply. |
AuthorErica ArchivesCategories |